Matco-Norca™ Pipe Patch Clamp, Series: 330, 3/4 in Pipe, 304 Stainless Steel, 3 in W, 50 to 240 deg F, Domestic

• Round corners with sheared edges turned down, eliminating the danger of small cuts or nicks during installation
• A long carriage bolt with extra large shoulder that prevents the bolt from spinning during installation
• A double chamfered oversized nut that allows easy hand tightening
• Clamps: Pre-formed at the factory
• Drop in bolt eliminates loose parts and allows for easy "one hand" installation
• Stainless Steel Band: Double slit so that edges on both sides of clamp turn under, this eliminates sharp edges which would cut your hand
• Lugs: Cadmium plated malleable iron to protect against rust and corrosion
• Bolts: Have an extra long square shank, other bolts have a slightly rounded shank that allows the bolt to turn
• Nuts: Oversized, allowing easy "one-hand" installation
• Malleable iron lugs- electro galvanized with dichromate finish
• Carbon steel Bolts- electro galvanized with dichromate finish
• Carbon steel nuts - electro galvanized with dichromate finish
• SAE flat washer - zinc II plated
• Gridded nitrile Buna rubber gasket is especially resistant to aromatic hydrocarbons, gasoline, petroleum oils, mineral oils, vegetable oils and natural gas
• 150 psi

• Specification Sheet https://www.hirsch.com//ASSETS/DOCUMENTS/ITEMS/EN/https://assets.unilogcorp.com/2/ITEM/DOC/Matco_Norca_330033_Specification_Sheet.pdf